Setting tonearm angle?


I recently lucked out and got a great deal on a VPI Scoutmaster 2 with JWM 9T arm and proceeded to set it up.
I had never owned a high end table like this so the set up was a bit new. My question concerns the VTA of the arm. I set it by measuring from the bottom surface of the arm to the record surface at several places along the arm to get the arm as close to level as possible.
Is that a logical thing to have done? Would the sound better if the angle was biased in one way or the other? (Dynavector DV-20X2 H cart being used) Thanks.
rmcfee
Actureus

"Why would the azimuth change when you adjust the VTA? The two are set in two different planes. The SRA and overhang, sure, but not the azimuth. "

It depends on the arm design. If the bearings are at right angles to the arm tube then the cartridge will tilt as it is raised and lowered. The bearings should be at right angles to the plane of the cantilever movement.

For a unipivot, it depends on the way the weight is distributed, or if it has a device like the Graham.

John
Raul, all,

Regarding the status of my knowledge re cartridge set up, I have come a long way since re-intering the vinyl wars some 6-7 years ago. Much time and effort has been expended in expanding what I know about better set-up.

That includes a DIY restoration of my Garrard 401, including plinth and mounting the arm (Dynavector 501). What I am able to enjoy now is so much better than my previious rig, a VPI Scout Signature.

I have found there is much to learn with the vinyl format, and that is why I enjoy it so much. I have learned a lot. There is much more yet to learn, (I don't think it ever stops in this hobby), and I will attempt to see what can be gained by checking overhang with changes in VTA. One caveat here, is my old eyes, which makes fine adjustments difficult.

I intend to modify my home made overhang gauge, so it can be used with the cartridge-headshell mounted to the arm.

Even without trying to fine-tune every parameter when VTA adjustments are made, the sound is always enjoyable, and quite good, I think. perhaps a bit more attention to detail will yield even better results.

Thanks to all, enjoy,
Dan
Dear Islandmandan: ++++ " I have found there is much to learn with the vinyl format, and that is why I enjoy it so much. I have learned a lot. " +++++

I agree with you, in audio everyday is a learning day. We have to be willing to learn and to have and open mind. We can learn from any one. Like you I learn each single day.

Regards and enjoy de music,

R.
I suppose I could be accused of stealing this thread, I hope you will indulge me.

After our previous discussion, I went a bit further in trying to fine-tune overgang/alignment last night.

I now know I have been remiss, in not optimizing overhang with changes in VTA. I was surprised by how much overhang was off, when checked with a MintLP tractor, made specifically for my Dyna 501 arm/Garrard 401. Less distortion due to incorrect overhang, made for a better listening session. I guess I'll have to stop my slothful ways.

Thanks Raul, and so many others that are the true worth of this forum.

Regards,
Dan