To those with multiple tables/arms/cartridges


How do you 'play' your system?
For 30 years I had only one turntable, one arm and one cartridge......and it never entered my mind that there was an alternative?
After upgrading my turntable nearly 5 years ago to a Raven AC-3 which allowed easy mounting of up to four tonearms......I decided to add two arms.
RAVEN
A few years later I became interested in Direct Drive turntables and purchased a vintage 30 year old Victor/JVC TT-81 followed shortly after by the top-of-the-line TT-101 and I designed and had cast 3 solid bronze armpods which I had lacquered in gloss black.
TT-101
By this time I had over 30 cartridges (both LOMCs and MMs) all mounted in their own headshells for easy interchange.
STORAGE

Every day I listen to vinyl for 3-4 hours and might play with one cartridge on one arm on one table for this whole day or even two or three days.
I then might decide to change to a different arm and cartridge on a the same table or perhaps the other.....and listen to the last side I had just heard on the previous play.
I am invariably thrilled and excited by the small differences in presentation I am able to hear....and I perhaps listen to this combination for the next few days before again lusting after a particular arm or cartridge change?

Is this the way most of you with multiple cartridges/arms listen?......or are there other intentions involved?
128x128halcro
Dear Lewm,
i tried both ways, a switch with relais (Manley switch) and the silverswitch of Dertonearm. While the Manley is a really good design I stayed with the UNIswitch. Of course you always have a degrading when putting units in between the lines but this unit keeps the qality in a very satisfactoy way.

Another option is going for the EMT JPA-66 with four tonearm connections (one MM, three with inbuild SUTs) and two line connections. This is in my eyes the most versatile and best sounding tube phono pre, also and especially regarding MMs.
Although I tend to take a purist approach to audio. (No tone controls, minimal switches and connectors, etc, etc.) I have lately come to believe that some of these gospel truths can be occasionally violated with no important negative consequences.

Nandric, In the US, students are typically graded on a scale of A to F, where F = Failure. An "A" student would be in the very top category.

Case in point re violating gospel: The other night I set up my pair of Beveridge 2SW speakers, which I have owned for more than a year but which I had never heard, because I sent the direct-drive amplifiers off for check-up and upgrades the minute I uncrated them. Just got them back after 8 months. All I had on hand in my basement as a signal source was an old tuner, the preamp section of an old solid state NAD integrated amplifier, and some ancient "give-away"-quality RCA interconnects. Also, no woofer to complement the Bevs below 80Hz. (The 2SW has a built in 12db/octave x-over at 80Hz; you need a woofer/subwoofer.) Nevertheless, I hooked the tuner up to the NAD preamp and the preamp to the Bev direct-drive amplifiers which sit in the bases of the speakers, set the tuner for a local FM high quality classical music station, and fired up the Bevs for the first time. After about 15 minutes of warm-up, the sound was absolutely glorious. I was riveted to the spot for two hours, or until 1 AM, when I finally had to get some sleep. This to me was a demonstration of the primacy of the transducer. All the other gear is merely seasoning on top of what the speaker can do. If the speaker is second rate, no amount of audio jewelry or switch avoidance can overcome that. If the speaker is of high quality, you almost cannot miss.
Dear Henry, the most important fact in our hobby is what
one self believes. The other may believe, for example, that
those thin gold platings on the connectors wear off even
from looking at them. But the theory that they get better
by each put in /put out exertion is remarcable. How often
do you need to change all the connectors involved?
Once again Lew.......we find ourselves in agreement.
Unlike the famous Linn philosophy which attracts adherents due to a simple logic........if the speakers can't create 'magic'.........no source will compensate (IMHO of course :-))
Henry, The particular FM station I tuned into plays classical music only. At that time of night, they have a female disc jockey who has been doing the late shows for decades. I have heard her voice on many many different speakers and in many different systems. When she came on the air in between musical pieces to announce the time, the news, or what music was coming next, it was almost eerie; she seemed to be sitting no more than 6 feet away from me. (I know this is a tired audio cliche', but it does apply.) I could sense the resonance of her body as she spoke. That Beveridge guy was clearly a genius of sorts (maybe not an "Einstein" but a genius nevertheless); there is much about the speakers that is totally unique, even including the way the ESL panels work, which is fundamentally different from all the other successful commercial ones. The diaphragms do not carry a high DC bias voltage, which may be why my speakers still work so well after 34 years. (Built in 1979.)