Acrolink in-wall cabling?

Note that I suggested that it would be appropriate to use the expensive in wall wiring *after* installing a power regenerator at the panel. Otherwise whatever grunge is present at the breaker panel is only going to be more faithfully reproduced at the outlet.

I appreciate your pride in having spent a great sum for wire to place inside your walls. I just don't believe that is the best way to get pure power to your rig unless you have a pure power source. If your house is supplied with perfectly clean power and your appliances are not introducing any noise back onto the home wiring, then your application may benefit for a $4000 run of AC conductor. For the vast majority of people who take their power from the public mains, they would do better to spend that $4000 on a few regenerators like the PS Audio Power Plant and some good PCs.

You're right Proclaim123. When it comes to disposable income, everyone should be free to dispose of it as they see fit without the outside pressure of conscience.

As with all things in high end audio, much of the benefit lies in one's perception of value. If the performance gains of $30+/foot in-wall wire are perceived as valuable, then one should buy it .

Unfortunately, or may I add possibly fortunately I do not have an unlimited source of $$'s. If we all did It may have a tendency to get us into trouble. I might add that we would have some awesome equipment. Since the Acrolink is that expensive, I have not nor will be purchasing it. Just wondering if there is a better solution than just Romex at a blue collar dollar. Thanks again...Joe

Joe....the Romex and/or Handiwire can be cryo-treated (I perform a double-treatment on cabling, wall receptacles, and other electrical parts....of course, this methodology is for another discussion), which will greatly increase the performance of either less-expensive choice for in-wall wiring. That will work out to between $1.50 and $2.40 per foot (for either a single or double treatment), far less than the Acrolink solution. Proper cryo-treatment is a cost-effective and permanent enhancement, and certainly a good choice over stock wiring.

With the number of used plants available on Audiogon, the power plant option is a very viable solution and improvement.
What I have done with both my P-500 and P-600 is to open them up and remove the ferrite rings which were installed by the factory. Then replace the PS Audio ports on the back with the flavour of Oyaide outet I wish to substitute. I liked both the SWO-DX and SWO-GX (Rhodium over silver and palladium over Gold)
This slight mod which is so easy to do, seems to improve the performance of the PS plant units.