ac cables falling out of IEC inlets on amps

I had the same problem. Use Blutack. DO NOT USE THE GENERIC GARBAGE, OR YOU WILL BE SORRY!

Tvad- I've tried tape with only partial success. It seems the inlet is slightly tapered, so taping Marinco connector prevents full insertion.
Kenscollick- Your tip of bending the contacts might have some merit. My incentives for replacing the IEC include thr understandin that some are spring loaded and exert a thght grip. Also, I am attracted to the idea of moving up in quality, if it would improve the sound of my system.
Thanks, pummy

The heatshrink method works better than electrical tape, but the tape is easier to find and to use for some people.

Anyway, it sounds like you're on a mission to replace the EIC outlets.

Good luck!

Fatparrot-
I take it you have tried blutack and it worked out well for you, and you tried some other brand and it didn't. Can you say a little more about your experience?
pummy

this is amazing as I just sent my mono block amps off because of this problem...