2. cables
  3. 1220962898

Using bi-wire cables on non-biwirable speakers

This question may be filed under the 'noob' category but I will present it anyways at the risk of revealing myself as being underinformed. I am going to take the plunge on a pair of Dynaudio speakers a lot sooner than I was expecting to. I am currently using Synergistic Research Signature X10 biwire cables. Is there any harm in using these cables on pair of speakers with a single set of binding posts? If so, should I use the pair of the jumpers labelled 'high' or 'low' or one of each? Thanks to all in advance.

Adam
adamg
jallen
502 posts
 
Put them both on the binding posts. This will do no harm. Don't dangle unused cables...an amp disaster waiting to happen. Jallen
adamg OP
89 posts
 
Thanks Jallen. Just to clarify - both banana's in the binding post? Is this possible?
ifrt431
10 posts
 
Puting both on the binding posts works, but seems to mess up the imaging.
adamg OP
89 posts
 
It seems as though I really should just purchase an inexpensive pair of speaker cables to hold me over until a proper replacement becomes available.
eldartford
4,262 posts
 
There is scant (but not quite zero) scientific reason for biwire connection to speakers that have separate connections for the woofer and tweeter crossover sections. There is absolutely nothing to be gained by running separate wires to a common woofer/tweeter connection.
More to discover