Speaker cable made in USA?

Please don't overlook GroverHuffman.com handmade cables.

DH Labs T-14 wire is very good, for a modest price.

http://www.silversonic.com/docs/products/T14.html

Silver Sonic T-14 High Resolution speaker cable was designed by D.H. LABS to provide the highest quality sound at a much lower price than competing cables. It uses the finest materials available, including silver, oxygen-free copper and a pure Teflon dielectric.

The cable is completely manufactured in the U.S.A. The process begins with strands of high purity OFC copper, which are individually coated with a thick layer of silver. The strands are then tightly wound and extruded with our Teflon insulation. Silver Sonic T-14 uses DuPont PTFE, which is the highest grade of Teflon (and the most expensive). The cable has a very low capacitance of 21.5 pico-farads per foot. The inductance is also very low, which allows consistent performance with a wide variety of speakers. In fact, a ten foot length of T-14 cable has less inductance than the output stages of many amplifiers! Vibration damping spacers and a tensioned wrap under the jacket hold the conductors tightly in place, and the cable is completely free from resonances and microphonic effects that cause a loss of resolution. From the deepest bass to the highest treble, T-14 provides the most transparent sound possible, with precise imaging and a large, deep sound stage.

Our quality is second to none. We test every spool of Silver Sonic cable , and our Teflon insulators exceed mil-spec. T-14 is available in bulk lengths, or factory terminated with your choice of connectors. For more information, please contact D.H. Labs.

highly complex designs with a lot of science behind them...tell me the name of the scientist that are designing audiophile cables Raquel...if any cable manufacturer, writer, technician, etc. can identify such an audible design parameter that cannot be measured using available lab equipment or be described by known theory, I can guarantee a nomination for a Nobel Prize. You have been hood winked into thinking this and so continue to spend hard earned cash on special configuration wire that sounds no better then the anti cables that are nothing more then solid core wire,,certainly nothing high tech about that.

Uh-oh...my asbestos suit is at the cleaners! Take cover!!!

There are other reasons people might think they hear the sound change even when no change is likely. One is the limit of auditory memory - if it takes 15 minutes to swap a set of speaker cables, it will be more difficult to recall the original sound when compared to switching quickly between two different sources. Crawling around on the floor will also likely raise your blood pressure, which can affect perception. We also hear differently early in the day versus later when we're tired, and just listening for a while can change our perception. Does that solid state amp really sound different after warming up for half an hour, or is it just our perception that changed? Add a couple of cocktails to the mix and then you really can't tell for sure what you're hearing! This was written by Ethan Winer and it makes allot more sense to me then spending hard earned cash on something that just might not be there.