WA-Quantum GmbH's Quantum Chips

Placing a WA fuse chip on top of one end of a standard fuse did make an audible improvement.

I took out a pair of Supremme fuses I was using in my Acoustat servo amps and re-inserted the two stock fuses without the chips.

The sound was less focused and a bit shrill.

Adding the WA chips to the stock fuses improved the sound,and made the stock fuse sound more like the sound the amps had with the Supreme fuses.

Sounds too good to be true doesn't it?

I then took the chips off one amp only and listened.

The sound of the amp without the chips again sounded more grainy, less smooth than the amp with the chips.

I was about to try the Nano fuses,but I think I'll quit where I am at and enjoy the sound as it is.

This has to be the cheapest ,most effective tweak I've ever experienced.

Well I placed the "Power chip" on the side of the Main Power Breaker.
Is that The best place?
I wonder if it needs to be touching metal such as on the circuit breaker box...
Those of you with the power chip, your advise is appreciated.

Ozzy, I have two Power Chips. One has been outstanding on my new HB Cable Designs PowerSlave power strip at the IEC plug. I have tried three positions on my power panel without being at all satisfied. Mine in inserted into the wall. I have tried inside on the top, on the particular breakers, and under them in the unused area. I have also tried it on the wall outlet.

The one on the power strip is so musical, real, dynamic, and sweet that I am most satisfied to just use it. This maybe the most effective Chip. Of course, I have not removed the others, so it maybe just the final brick in the wall.

I have continually found these WAQuantum Chips breakin. Initially the bass is boomy and ill defined and the top end is just not there. Three hours later they are much better and two days later, divine.

Davidpritchard, your experience with instruments means that it is vibrations that are being effected not electrons. I had an experience in NM that suggests otherwise. I had put one of the ic Chips on and enjoyed the improvement. Later that evening while still enjoying the sound, I noticed that the chip on one ic was just hanging from one corner. As the sound was not affected, I assume this meant some non-vibration impact. But on speakers I have found that scotch tape is inadequate for attachment. The Chip needs to be directly attached. Finally, the new Power Chip just sitting on my HB power strip has a big effect. I have yet to directly attach the Chip.

Sgordon, I am going to try you outside use of the Power Chip. How do you protect yours from the weather?

Tbg, thanks for the response. I have found that 2 Cable chips on my Circuit breaker seem to add more dynamics, but I couldn't discern any change with just the Power chip.
Perhaps, I need to experiment further with its placement.