Is this why my analog rig isn't so hot?


Hi All,

My system is quite decent, but...

Could it be the voltage output of my Benz Glider is too high?

My photo stage - a 47 Lab PhonoCube - could handle low outputs down to 0.12 mV. Since my Glider has a medium output (0.83 mV) - is this why I'm not that happy with my system? I seem to want to hear more, specially the top.

If I got the same Glider but with a lower output, would it make a difference? Or should I get a better cartridge? And which one?

My system:

Basis 2000 table
RS-A1 Lab arm
Benz Glider (0.83 mV)
47 Lab PhonoCube phono stage
47 Lab Chooser passive preamp
47 Lab Gaincard amp
Konus Audio Essence speakers

Thanks!
George
ngeorge
Dan_ed

>>Careful, don't commit to a real position on anything too specific.<<

2nd time that you're accusing me and not reading my comments properly, its here again if you can read. What can be more specific than this?

>>The 2000 series is highly colored, has a dark over all character with rolled off highs, very limited bass, if any at all, and anemic mids.... you can add upper bass hump to the suspended model<<

You might not like what I have to say but don't accuse of me of not taking a position and being vague. I don't see why you're trying so hard to make things personal instead of posting a relevant response to the problem.

Mama
Hi George,
Wow? Hardly. ; )
As always, take any recomendation with a grain of salt. fyi- my range of recs reflect a somewhat less PRaT-oriented bias than I would personally choose for myself but more than those of the vast majority posting on this board.My thinking is that your requirements fall somewhere comfortably (and sanely) between round and flat-earths, favoring a direct,lucid,lively presence, with tonal purity, ease and authority- middle earth if you will.The decks mentioned still vary considerably in their presentations of music however.caveat emptor right attcha,dude. hehe

best,
k
George,
Also toss in the upper end Well Tempered decks to the mix.Often available used at reasonable prices.

best,
k
Dear George. As I already told you ( my first answer ) I think that the problem is in your electronics and that you are using a cartridge with the wrong internal impedance for your phonocube.
There are not such " general rule " in turntables about " nimble" sound. I have more than 35 years in testing analog rig and, beyond what Ken told us, the 70% to 80% of the quality of the sound reproduction comes from the tonearm/cartridge combo, here it is where we have to look which cartridge mates best with what tonearm. The Basis is a good turntable by any standards and it can't be the responsible for the high frecuency response problem. No I don't own a Basis turntable ( but I hear it many times ), I own severals turntables ( at least three of them of the high mass version ) and I can tell you that the TT is a very important link in the analog chain but not at the level that Ken told us.
Now, there are many issues on your high frecuency problem because any single link in your audio system chain is important: room, electronics, loudspeakers, cables, position of your loudspeakers, etc... You have to check before you move to other turntable. Right now you know that your electronics are truncated at the top end and that you are using a wrong internal impedance cartridge, so you have to evaluate any single part on your whole audio system for to know which will be your first move.
Regards and enjoy the music.
Raul.