B W 802N how much power?


802N are on the way....currently i have a Levinson 335
250 watts/8 ohms... do we find that is adequate...i have heard mixed comments...
128x128rocky
I am driving my 802s with Sonic Frontier Power 3s which is rated 220watt/ch. I find this power to be more than adequate. Don't forget that 802s are very efficient speakers (8 ohms). I have heard them being driven by a Lab 47 amp which I think is rated something like 7 watts, and I was blown away by the 802s' dynamic and its full bass performance. I don't know what type of music you listen to, but I have never turned my CAT preamp pass 9 o'clock on the volume knob (starts at 6 o'clock). These are my 2nd pair of 802s, I think they are really great speakers for their value and sound quality. Email me if you any question with these speakers. Good luck.
I have my N802's in a 14x15 room with an 8-11 ft. vaulted ceiling that is open at top extending into another 10x25 ft room. I was using a Classe CA300 which had more than adequate power, probably a little too much as the soundstage was humongous, very open and dynamic. I also used an older Classe DR8 which at some 100W had more than enough power but not the same ease or bass extension of the larger amp. My desire was for a more intimate soundstage and harmonic balance that I hear through my Cary system. I didn't know how much power I would actually need from a tubed amp and settled on a power rating of about 100W. I purchased a VAC PA 100/100 used and find that it will play as loud as the big Classe except I sacrifice extension at both the very top and bottom in exchange for a lush midrange and fuller bass that I believe only tube can accomplish. So my final opinion would be that 100W solid state or 50W tubed would be sufficient depending on the size of your room and how loud do you want it. By the way the peak level that read on my Ratshack meter at the listening seat 10 ft away has been 107 db with the big amp and 103 with the VAC. This to me is very loud. Normal listening I usually peak at low to mid nineties with the average spl's in the eighties.
Give your levison gear a try. It might be enough of what you are needing, in terms of power. I originally had mine set up with a pair of Aragon Palladiums, which are rated @125 watts into 8 ohms. After hearing a friends 801s with a pair of Bryston 7bs, I ended up making the switch. The power difference was immediately felt,and my overall listening enjoyment improved. Just a footnote. The 802s sounded great with the palladiums, They just kick ass with the 7bs.
I have 802Ns in a large room (18x33 w/vaulted ceiling. I have tried McCormak 225, Plinius 100 Mk.III, Joule Elec. 150 watt vamp, Rowland 10, Clayton S-40, and currently have Clayton M-100 monos and a MacIntosh MC352. The 802s can take a huge amount of power and sound better and better--they are fabulous speakers. I like the MC352 best of the lot because of the synergy: the tonal balance is just superb. But of course there is the rest of the system contributing. I am sure you will like the sound of your speakers with the Levinson. I am also sure you will desire to extract even more performance from the bottom. The only real compromise in the speaker is the extreme bass. That limitation doesn't get in the way from a music lovers point of view though. And only occasionaly from an audiophile point of view. Overall I think the talk about needing more power than you already have is over the top. Your speakers are going to sound great.