Graham phantom MK2 /. Simon Yorke S10

Rilou,

I run the 10", traditional Graham/Linn mount on my clear audio table for mono playback and a 12" on my TechDAS in the rear position for stereo. I am still waiting for production to finish on my Graham Phantom Elite arm 10" that I will run in the TechDAS's main arm position. I have sme mount for the TechDAS. Sme gives you a little fore and aft movement once mounted, whereas the Graham mount has to be drilled perfectly unless you are using a cantilevered arm board like those on the clearaudio innovation.

On the mount, it depends on the table you have. The Graham mount is physically smaller, which allows the arm to be mounted on a wider variety of tables. I also found it very easy to install and set up.

Arm length also depends on the table, but is also a cartridge compatibility concern and personal preference. Other forums have a world of info on the merits (or lack thereof) of long arms. For my application, the 9 inch arm was the way to go.

Have fun & good luck!

I had all Grahams in all lengths, the best one is Standard 9" with Graham mount. All mounted on the same table, used with same cartridges and compared / controlled each one to correct geometry, best tracking results with various pressings.

Thanks for all.
Ok Syntax
I go to Graham phantom 9 with graham Mount.
Which Cartridge?

Thank you again

I have an SME V armboard. Will the Graham SME mount mate to the SME V's mounting holes? I tried asking Graham but no reply.