At high volume, my 4BSST would flash red driving the 3.6. They suck power and need to be fed. Try a 14bsst, a bit more power will help, or get a bigger Pass. Jallen
Pass 250.5 shuts down driving Magnepan 3.7
This is my first post so please bear with me.
My Pass labs 250.5 protection circuit shuts the amp down when I drive my new Magnepan 3.7s at high volume. I'm talking about a volme higher than I might consistently listen, but not an unbearable level.
I'm using a Cary Slp 05 preamp with long balanced ICs (25 ft,) The amp is close to the speakers with less than 6 feet of speaker wire. The system works fine at normal volumes. I've tried the same thing with a pair of Cary MB500 (750 W @ 4 ohm) and they too shut down at high volume.
I believe the maggies drop below 4 ohms and I wonder if either amp can handle the impedance drop below 4 ohms.
Has anyone experienced this issue ?
Any suggestions ?
My Pass labs 250.5 protection circuit shuts the amp down when I drive my new Magnepan 3.7s at high volume. I'm talking about a volme higher than I might consistently listen, but not an unbearable level.
I'm using a Cary Slp 05 preamp with long balanced ICs (25 ft,) The amp is close to the speakers with less than 6 feet of speaker wire. The system works fine at normal volumes. I've tried the same thing with a pair of Cary MB500 (750 W @ 4 ohm) and they too shut down at high volume.
I believe the maggies drop below 4 ohms and I wonder if either amp can handle the impedance drop below 4 ohms.
Has anyone experienced this issue ?
Any suggestions ?
- ...
- 35 posts total
- 35 posts total