2. tech-talk
  3. 1149223584

Installing dedicated lines. Which cable to use?

Hi guys

I'm having some dedicated lines put in. I've already purchased some Porter Ports (what a great guy that Albert P.!), and have a couple of questions concerning which cable to use. I want to use 10-2 solid core, but am confused about a couple of things:

-the runs from the breaker box will be relatively short (15-20 feet). Should I use shielded Romex or unshielded? I do have some problems with noise (hum, buzz)in my setup when using unshielded interconnects (Nordost). I am told that unshielded sounds better but is noisier. Experiences?

-I am having trouble locating brand name Romex. The local HD and Lowe's don't carry it, but do have a Romex-like 10-2 copper wire. Is real Romex worth the search? Lots of references in the archives to Romex from HD. What gives? Is the name Romex used generically to mean any similar cable? What is a good source for real Romex?

Thanks in advance and any other suggestions or tips would be greatly appreciated.
frogman
nrchy's avatar
nrchy
2,111 posts
 
Porziob is completely wrong. Making your own wires as Sean suggested is economical and completely up to code. Lots of electricians do it every day. My office was wired that way, FWIW.

The only thing I would change from Seans recommendation is to run the ground seperately. Not just outside the jacketed romex, but one feet away from the others is possible. I did that at home and the results were worth the effort.

Bignerd is right with his last comment, but look where you are right now...
sean
6,229 posts
 
As Bignerd stated and Nrchy affirmed, so long as one uses the appropriate wiring, the geometric configuration of the wiring isn't critical so long as it is properly terminated. If in doubt, check with the local inspector and / or discuss it with a licensed electrician.

As to Nrchy's comments about separating the ground wires as much as possible, i agree. This is especially true if the grounding system has been optimised. Having said that, just getting the ground wire outside of the hot / neutral bundle is of benefit, hence my recommendation to do so.

How far one wants to take all of this is up to the capacity of their wallet. Obviously, better performance can be had over what i recommended. In terms of bang for the buck, convenience and effort required, the approach that i mentioned will be hard to beat. You could do FAR worse for a helluva lot more time, money and effort using much more expensive "audiophile approved" gear and methods. Sean
>
1markr
525 posts
 
So, is it recommended to use solid 10 ga. wire, or will stranded suffice? What would the difference be?
frogman OP
4,637 posts
 
Follow up questions, and thanks again to all:

-My outlet boxes will be surface mounted in order to protect antique wood moulding. Anyone know a good source for sturdy plastic surface mount boxes?

-Also, does it make sense to run one of the three dedicated lines off of a different phase from the other two? This line would be used for the digital gear. Will this arrangement further isolate the digital from the analogue gear?

-Am I losing my mind? :)
porziob
316 posts
 
You can melt your own copper, make your own dielectric, etc. At the end of the day you MUST MEET CODE.
More to discover