Sns,To break in all the caps, solder your caps together in series. Put an RCA on on end, and a 10K ohm resistor on the other end. Run a ground wire from the RCA shell to the other end of the resistor to form a complete circuit. plug this assembly into your pre amp out put. Turn on the Tuner, turn up the volume a third of the way, and go to bed. When you get up in the morning all your caps you soldered together will be broken in and you should be ready to try your experiments.
Don't waste your money on Audio salon caps. all you will need are available from Mouser or Digikey.
As long as you are working on the phono stage, why don't you replace the loading resistors with Vishay S102's? as well as any shunt resistors that are usually located at the output of hte phono stage. They will make as big or bigger difference than the caps.
Happy listening.
Don't waste your money on Audio salon caps. all you will need are available from Mouser or Digikey.
As long as you are working on the phono stage, why don't you replace the loading resistors with Vishay S102's? as well as any shunt resistors that are usually located at the output of hte phono stage. They will make as big or bigger difference than the caps.
Happy listening.