magnepan mmgs-buy zero autoformers or stands 1st?

hey, i'm forgetting something. the mmg's aren't even a week old and not broken in yet. bass should tighten up as they break in correct? i still think there is plenty of power because i'm getting plenty of bass, able to play loud without speakers breking up. and the boom i hear is only on 10% of material (maybe even bad recordings ). guess i will wait til these get fully broken in and then decide on next move. definitely keep these speakers and this amp is gonna run them. any thoughts on break-in time and how maggies will change as they break in? bass should tighten up correct? thanks alot

specs on my amp.........

Features:

1.Class AB,push-pull design delivering 40 watt output power.
2.A pair of EL34 output tubes running in ULTRA-LINEAR mode per channel.
3.12AT7 and 6SN7 dual triodes for input stage and drive stage (one 6SN7 drive pair of EL34).
4.Little negative feedback with precision RC circuitry for more linear output.
5.IEC Jack
6.REMOTE VOLUME CONTROL
7.SELF - BIASING

SPECIFICATION:

CONTROL FUNCTIONS: Volume, Input, Power On/Off
POWER OUTPUT: 40 watt x 2, RMS 1kHz
TOTAL HARMONIC DISTORTION: less than 1%(40watt, 1kHz)
FREQUENCY RESPONSE: (-3dB points at 10 watt) 6Hz-60kHz
INPUT SENSITIVITY: 180mV
INPUT IMPEDANCE: 100k
OUTPUT IMPEDANCE: 4,8 ohms. (User selectable.)
SIGNAL/NOISE: 90dB
CONSUMPTION: 90watt
INPUT INTERFACES: 3 groups (RCA) - 1,2 and 3
VACUUM TUBE: EL34 x 4, 12AT7 x 2, 6SN7 x 2
DIMENSIONS: 446(L) x 264(W) x 155(H) mm
WEIGHT: 17kg(net);17.5kg(shipping)\

Using the 8 ohm taps will tighten the bass more than the 4 ohm taps.

really?, thanks, tvad, but won't this hurt the amp, or speakers? according to maggie website, they say don't run on 8 ohm taps......

I have to say I'm completely out of ideas to help your situation Cooch. Good luck.