A-B testing of cables


I recently attended The Show in Newport Beach California, and I asked some experts how to upgrade my cables gradually. I was told to start at the source. I should upgrade the source interconnect first then gradually work my way through the system, and I should hear the difference at each stage providing I am using audiophile quality cables; so I bought some cables at over $600 a pair to try out. My current cables cost $250 a pair.
My system is composed of:
McIntosh C2500 preamp
McIntosh 601 mono blocks
McIntosh mcd 205 CD player
VPI Classic 3 turntable
Nola Baby Grand speakers

I bought two y adapters and connected one pair of new cable and old cable between the CD player and preamp to do an A-B test. I also performed the same test with the turntable but I could not tell the difference between the cables whatsoever. I was very surprised and disappointed at the same time. I could not believe it so I called in others to have a listen whithout telling them what I was doing and they too could not tell the difference.

Has anyone else tried this test? I would like to hear your results.
Am I doing something wrong?

What is your experience in doing A-B testing of interconnects?
almandog
Gorquin,

This does not surprise me. I have speculated about this before on the forum.
I would love to read a technical analysis of speaker cable "burn in" .

Is someone going to suggest that the cable needs time for the electrons to "Line Up" or "configure" in a specific order so that the cables sound good?

There are no moving parts in a cable. Speakers, sure I understand that conceptÂ….and they wear out.

I'm open to learn something proven by science. Who's got the White Paper on this?
Gorquin... you say...

"There are no moving parts in a cable"

Fact: there are billions - of electrons, proton etc. Just because you can't see it movin - just sayin :-)

- There is also the effect a cable has on the performance of the connected components - at both ends

- Certain architectures actually lower the noise on the neutral side of connected components

- There is seating of the connectors - a bond that can take days before optimum performance is achieved.

- There is the effect the insulation has on the cables performance - which over time can change for better or worse.

And that is just scratching the surface.

Having dabbled with cables for years I now have cables that actually allow my components to run cooler - simply because of their architecture.

The "science of cables" is only just (i.e. in the last 30 years) being investigated and understood - it is insanely complex and as such - "papers" are extremely rare.

Choose to believe it or not - scoff or investigate - your choice.

Right now - the proof is in the listening - not in white papers.

I have heard a difference many times - sometimes to my own amazement.

My cables are an integral part of my system and I consider them just as important (if not more) than some components.

But that is just my own observations - others may not experience the same.

If you are ever in the Toronto region - drop me a line and come on by for a listen - bring your cables - we'll have some fun trying :-)
It doesn't matter what you say, he'll never change his position. Its not about cables, its about him being right. Give him all the proof you want, and he'll come up some excuse, no matter how small, to invalidate whatever it is you show him. Here's an example.

Gorquin. Here's a white paper on Audioquest's DBS system. It goes over what break in is, and what it is not. You'll also see the patent number AQ has on this system.

http://www.audioquest.com/wp-content/uploads/2011/12/DBS.pdf
In my exprience, cable sound has much to do with what it is plugged into. The same cable sounds different in different systems. I suspect that to get the results of what the cable sounds like in your system, you would have to connect it in the traditional way. I'm not an electrical engineer, Y connectors have always damaged the sound of anything i tried it with.