Tekton Double Impacts


Anybody out there heard these??

I have dedicated audio room 14.5x20.5x9 ft.  Currently have Marantz Reference CD/Intergrated paired to Magnepan 1.7's with REL T-7 subs.  For the vast majority of music I love this system.  The only nit pick is that it is lacking/limited in covering say below 35 hz or so.  For the first time actually buzzed the panel with an organ sacd. Bummer.  Thought of upgrading subs to rythmicks but then I will need to high pass the 1.7's.  Really don't want to deal with that approach.

Enter the Double Impacts.  Many interesting things here.  Would certainly have a different set of strengths here.  Dynamics, claimed bottom octave coverage in one package, suspect a good match to current electronics.

I've read all the threads here so we do not need to rehash that.  Just wondering if others out there have FIRST HAND experience with these or other Tekton speakers

Thanks.
corelli
Pr,

I hope you enjoy your DI's when you get them,I really like mine.
Very good sounding speaker especially for the money.

I haven't heard anything about the Vidar amps,I quess they are finally available to buy.

I do have a Yggdrasil with more than 500 hrs on it and It's a nice dac almost as good overall as my direct stream jr.

Wiil the vidars be safe to use as a bridged mono block into 4 ohms if you choose that configuration.

Best of luck to you,
Kenny.
@porscheracer :

Have to ask, which Porsche? Or is it Porsches :)

I've had the Schiit Yggdrasil for nearly two years now, serving as the front end of three different systems. It has performed brilliantly and this holds true with the DIs as well.

Congratulations on your purchase of the DIs. Looking forward to hearing how they work out for you.

@kdude66 : the Vidar amp is not released yet...probably early next week. The power specs were given out by the designer so I am confident they are accurate. The designer did say the amp is rated conservatively.

@david_ten : I race an air-cooled 911. It’s an 87 Turbo chassis with wide 993 bodywork with a normally aspirated 3.6L engine.

I can’t wait to get the Vidar amps and DI speakers. I ordered the speakers over a week ago and have heard nothing since then. That concerns me a bit. I guess getting the internal upgrade and holes for the speaker grills added complicates the process.
@mazikrav, thanks for providing the additional info in your latest post. Assuming that the gain provided in the active buffer stage Mr. Hammel provided you with is similar to what is described in the Stereophile review you linked to, your initial statement that it provides little or no gain was correct. "Unity gain" = no gain.

So per my earlier comments it can be calculated that when you are listening to LPs you cannot presently drive your F3 amplifier even close to its 10 watt maximum capability (for a 4 ohm load), at least on the vast majority of recordings. And the same would hold true with respect to the 30 watt capability of the F7. Fortunately it sounds like that isn’t a problem given your particular circumstances and listening habits. But I would suggest that if you go to a different amplifier it would be preferable to obtain one having substantially higher gain than the 12.5 and 14 db gains of those amps. Most amps having power capabilities comparable to the F7, or more, would provide that additional gain. As I mentioned, a downside of the design philosophy underlying most of the First Watt amplifiers is low gain.

Finally, as added confirmation of all of this note the following comment by John Atkinson in the measurements section of the review you referred to:
As specified, the Placette Active Linestage (ALS) offers a maximum gain of unity; ie, the maximum signal level is the same as that of the source components driving it. Owners should make sure, therefore, that their source components offer a sufficiently high signal level to fully drive their amplifiers.
Good luck. Regards,
-- Al