Who has Luv for the Lyngdorf 2170 and is thinking about the 3400.

Glad you tried one,only one way to find out.

I don’t have di speakers,got rid of them first of the year,I have Silverline bolero supremes and also will be getting a set of Lawrence audio double bass speakers next week.

I haven’t upgraded my 2170 either,your going to have to take the main board out of the case to be able to solder the LPF caps and you might as well upgrade the speaker output wire at the same time.
I will do mine after I get a 3400 in a few months,I won’t be selling my 2170.I’m going to keep it for my 2nd system and or backup.

Would you say that rp got rid of some of the cabinet talk that the Zu’s have by nature.I know what they sound like I used to own them.

Happy Listening,
Kenny.

Omg, I would kill for a pair of Lawrence double bass. 
Need those 6 matching numbers for that though....ah well one day.
Please let us know how they sound with either Lyngdorf!

Lyngdorf arrived today, and I’ve been listening for the past few hours. Quite frankly..I’m amazed. I’m convinced the first time I had one, my other components weren’t a good match, because right now everything sounds so so good.

I knew digital was going to be top notch, and it is, but vinyl playback now is much better than my memory had me believe. Not only is it much better, it’s fantastic! None of that warm vinyl sound is gone, detail/clarity has improved, and I forgot how dead-quiet this amp is..

Happy camper here.

I do have one question for all owners -- the firmware on my 2170 is not up to date. I have two thumb drives, with the most up-to-date firmware loaded, but the Lyng. is not reading either of them for some reason..

I’m turning off the 2170 on the back power switch next to the power cable, inserting the thumb drive, holding down the standby button and then turning back on the power switch. Nothing happening. Manual says the front panel should read "Updating" and that’s when you should release the standby button...

Maybe I’m not reading the instructions properly or I need a new thumb drive.

Robelvick

Glad it has surpassed your expectations, especially on vinyl, as u say possibly a mismatch previously, it happens.
As far as updating, sounds like you are going through the steps correctly, with one exception maybe.
Just one question, you are putting the thumb drive in the slot marked sw update?
And I think you have to insert it BEFORE you first power it off not after wards.
Mine updated first try, using a pretty old drive so I doubt it is your drives.

Try it again inserting before you power off .

Yes, it is in the SW slot, and I tried inserting it before powering off.

Still no luck.  Re-reading the manual, it explains to load the software on to the Lyngdorf USB (provided) which I dont have.  My first Lyngdorf didn't come with a USB driver either...