preamp inverts polarity

Another excellent knee jerk reaction by the poster boy of knee jerk reactions. It’s not necessarily the recording engineer’s fault. It could the the mastering engineer. In any case there are no standards for Polarity. Any more than there are standards for dynamic range compression, another big fault that’s not the fault of the recording engineer. If you can’t hear Polarity, which in your case I imagine is true, then you shouldn’t worry about it.

kosst_amojan

Air is a single ended medium of transmission.

It is? Exactly what do you mean by that?

You can compress it much more than you can decompress it.

You can decompress air it until it's a vacuum, so it isn't clear what you mean here.

Costco is close but no cigar. For starters air shocks in cars compress as much as they decompress. Air is a compressible fluid. Pressure, volume, temperature, whatever. Hel-loo! Second, when the system is in Reverse Polarity the speaker drivers move OUT when they should be moving back IN and visa Versace. They are 180 degrees out of phase. Follow?

Cleedsy, old bean, a vacuum is created by evacuating air from the system not by compressing it. Hel-loo!

@geoffkait
Yeah, I can hear polarity. Been playing with that a while on my amp.

@cleeds
You kinda pointed out the point I was making. You can only decompress air to a vacuum. But you can compress air until it begins to change phase. Sea level air pressure is about 16 psi. That's the absolute limit to how negative a wave can be. But it’s not very technically difficult to produce 32 psi or even 50 psi pressure waves. That’s, in short, why air is single ended, why it’s natural character of distortion is low and even order, and why single ended amps best emulate the character of the medium sound travels through.

“why single ended amps best emulate the character of the medium sound travels through”

This is very intriguing. Does this have to do with how the electrons move to create voltage to drive the speakers or something else? Hard to connect the dots.