Highest detail cartridges


Which cartridges give the greatest amount of detail? Imaging, soundstage file detail. These are qualities to consider. I know Lyra cartridges are high on that list. What others equal or better Lyras. Is there anything below, say $1500, that is in that same category?  Detail with reasonably flat frequency response.
bpoletti
"Is "closer to the music" a more accurate reproduction of what is in the groove or a "romantic" rewrite?"

If the romance of the original performance is conveyed in the recording, accurate reproduction of the groove is more than sufficient.

If it isn’t, I have no issue with restoring it, if I can.
An ART-9 just came up for sale on Audio Asylum Trader. No knowledge of the seller, not an endorsement, etc., etc.
@bimasta - How can you tell?  Maybe it is just a mediocre performance.  I prefer accuracy over distortion.
How do you determine accuracy? Were you there when the recordings were being made, or is “accuracy” a subjective assessment?

I think this a more than fair question as, in the last 50 years, I have been able to determine gross colorations, but past that, I really don’t know what criteria would qualify a piece of gear as being “accurate”.

Ill go a little further. For the sake of illustration, two amps measure the same, except one has .2% more 7th harmonic distortion and the other has 1% more 2nd harmonic distortion. Objectively, the later amp has an order greater distortion and is the less accurate. However we also know from the work of Hiraga, et al, that higher, odd order, distortion is much more jarring to the ear. The higher quantity of distortion in the second amp will be more consonant with the fabric of the music and thus more accurate. This is also why small amounts of IM distortion are subjectively worse than harmonic distortion, as IM is not correlated with the musical signal, whereas harmonic distortion is.
@viridian I listen to 99%+ classical music.  Instrument timbre can expose the accuracy of the recording.  And I've been a part of blind listening sessions that used two components that were identical except for a 3 millibel difference in frequency response.  The same component could be consistently identified during the tests.  

I prefer components with a vanishingly low amount of distortion to any distortion including even order distortion.  It is why I use one particular electronics manufacturer.