recommendation for speaker wire to soften the highs if possible
Hello, I need help. My problem is my system sounds harsh on the highs to me. Not extremely bad, but enough that I need to fix it. My system consists of Ryan 610's, oppo Sonica Dac, and a Belles 150a hotrod amp. Speaker wires being used are old monster cable from the 90's. I also have monster cable rca. I mostly stream through Tidal. My question is can I make the desired effect by switching cables or should I add a tube amp or pre amp. My budget on the wire would be around 300.00 Thanks in advance for any suggestions
I had the same problem in an earlier set up an the solution for me was Supra Classic speaker Cables. It doesn't cost much to try if these cables will solve your problem.
Who could say they disagree with the Gingerbread Man?""
Run, run as fast as you can!
You can't catch me. I'm the Gingerbread Man!
"" Never the less, watch out for Foxes...
OP, I assume you are streaming "hifi" $20 pm from Tidal.
Do this and I guarantee you’ll be amazed. Replace your Monster wire with 14/2 Romex from Home Depot. Be careful not to score the copper when you trim the insulation.
You must have a verified phone number and physical address in order to post in the Audiogon Forums. Please return to Audiogon.com and complete this step. If you have any questions please contact Support.