Another favorite cartridge vanishes.. Dynavector 17D3. GONE! replaced..

 Elizabeth, you are certainly entitled to do whatever you like with loading your 17 D3. However be aware that at 60 ohms you are dumping a fraction of the audio signal to ground, and there will be a high frequency roll off at frequencies probably lower than 20 kHz. This is a fact, not theory, not opinion.

Golly, Maybe the audiophile police will come and take me away!    (one can only hope)                       
I will worry about it when it sounds bad... LOL

Maybe.

Facts have little say in what any given persons brain decides to hear .

Dear @bill_k  @hdm @slaw : Dynavector never manufactured/designed a cartridge where the cantilever and stylus were made from one solid cantilever/stylus. Dynavector always made it as the 99% of LOMC manufacturers: two pieces.

If my memory is good only two cartridge manufacturers did it cantilever/stylus as one piece and these cartridges was: Audio Technica AT1000 and Sony XL88D ( I owned both. ). Both one piece of diamond. maybe could exist a third one that rigth now I can't remember but certainly Dynavector was not one of them.

Regards and enjoy the MUSIC NOT DISTORTIONS,
R.