2. amps-preamps
  3. 142369-117192

This question is aimed to TRUE Elec Engineers, not fuse or wire directionality believers.


Has any of you ACTUALLY worked with and recommend a SSR which does not introduce any audible distortion on the speaker line and which can operate with a large range of trigger voltages (12 - 48 VDC, may need to have on board voltage regulator for this range).  I am building a speaker DC protector and do not want to use electro mechanical relays becoz of DC arcing and contact erosion issues.  It needs to be capable of switching up to 15 amps at about 100 volts.

Only TRUE engineers reply please.

Thanks

cakyol
cakyol's avatar
cakyol OP
112 posts
 
Unfortunately, these are about $220 -> $320 on average:

https://omronfs.omron.com/en_US/ecb/products/pdf/J144-E1-05.pdf

Hopefully an SSR will replace this.

georgehifi's avatar
georgehifi
4,966 posts
 
Even NASA uses fuses
That's how they got Apollo 8 to circle and come back, they just reversed the fuse as they went behind the dark side of the moon, the rest is history.
stevecham
3,298 posts
 
But there is no dark side of the moon; as a matter of fact it's all dark.
atmasphere's avatar
atmasphere
7,068 posts
 
As long as the MOSFETS stay hard on between 20 - 20khz it will be fine :-)
Yup- if they are On, then the frequency is almost irrelevant.
imhififan's avatar
imhififan
652 posts
 
I have +/- 90 Volt rails.
This is more like it:

https://www.mouser.com/ProductDetail/Infineon-Technologies/IPB017N10N5LFATMA1?qs=sGAEpiMZZMshyDBzk1%...

100V, 180 amps, 1.5mohms (almost lower than the speaker wire itself), about 80 nanosecond turn off time (increase that becoz of inductive speaker load) and only about 8 bucks a piece.
I think you need higher voltage rating than 100V

http://www.geofex.com/Article_Folders/ampprot/dcprot.htm
More to discover