Behringer DEQ2496 - worth using in hi-end system?

Great, thank you very much Eldartford!

Kenn39...You raise a good point. Being aware of this I have set up low gain power amps, so that my "pre-out" signal level is as high or higher than the CDP output signal level. This is why a TAPE loop, if you have one, is the best place to put any signal processor, BehringerDEQ2496 included.

I've decided to give the Behringer DEQ2496 a try. It will be necessary to install the unit in my tape loop, so I'm ordering adapters.

What do you owners recommend for interconnects? I'm more likely to purchase something neutral in tone and reasonably priced...not my usual Purist Audio stuff.

Also, I presently use my tape loop output for another purpose. Does the Behringer have a second set of outputs that I can use ? All I saw in a photo were phono jacks. Do I have to purchase Male Phono/Female RCA adapters? If so, from where?

Finally, the best price I've found is $299 on Zzounds.com, or Musiciansfriend.com. Any better sources?

You might want to try using it between transport and DAC. Actually, I know you can't do that, Grant, so use it between transport and preamp.

Don't forget to order the microphone.

06-11-06: Drubin
You might want to try using it between transport and DAC. Actually, I know you can't do that, Grant, so use it between transport and preamp.

What are the benefits of this method over the tape loop method, other than freeing up the preamp's tape loop for another purpose? I was thinking the tape loop method offered the flexibility to completely bypass the EQ if I so choose. Placing it between the CDP and preamp does not offer this as the signal still runs through some EQ circuitry even if the bypass switch is engaged, correct?

Also, placing the EQ between CDP and preamp dedicates the EQ to just the CDP, and my other sources do not benefit from the DEQ2496.