Magnepan MG1.7 fuse question

5560, I found upgrading fuses on my 3.7's from stock to Audio Magic LA fuses was well worth it. I can't tell you what amperage the 1.7 uses. I would wait until you get the speakers at which point you will be able to tell what amperage to replace them with. They will be fast blo fuses. I also found getting rid of those nasty stock jumpers to be very worthwile. Both of these tweeks resulted in an immediately noticable reduction in grain.

I stuck four aftermarket fuses in my new Magnepan 3.6s I got two years ago.
They are the only aftermarket fuses i would bother with, since they are in the signal.
I am dreaming of going to 20.7 or i would just remove the fuse on the midrange panel of my 3.6s.
I agree just wait until you have the speakers..
Then by the time you get the aftermaarket fuses, the new 1.7s will be broken in better..
My 3.6s took half a year to really break in.

This is from the 1.7 manual:

The terminal plate states a maximum fuse value of 4 amps Type 3AG ("normal" or "fast blow"). The bass section
does not require fusing protection. This fuse value should never be increased or bypassed. Do not use slow-blow
fuses. BURNED OUT TWEETERS ARE NOT COVERED UNDER THE WARRANTY.

HiFi Tuning Supreme 4 Amp Type 3AG.
Empirical Design Jumpers.

I remember that burned tweeters not covered and You make a good point to install the correct fuses.
Thanks