2. analog
  3. 1233029609

Turntable set up HELP

OK, I have majorly messed something up and need expert advice. I set up my turntable a few months ago, and had no real problems, but I wanted to take it to the next level so I bought a Walley Tractor (well I ordered it in October, got it in January) and I tried to use it today. Well after I adjusted the cartridge using the Wally tractor, re-adjusted the needle force and anti-skate and put on a record. Well about 2 minutes in the record started to skip. Adjusting cartridge force again, anti-skate nothing helps. All the records skip. Platter is still level, I can't figure it out. Took everything off, re-set up, still skipping???

Help!!!!!
macdadtexas
Ag insider logo xs@2x
isanchez
276 posts
 
Macdadtexas,

You should check if the VTA changed from the previous setup. If it did, after setting it up correctly, adjust the tracking force again.

Best,

iSanchez
dougdeacon
3,338 posts
 
Cartridge wire brushing the LP surface could cause skipping on some thicker LP's and also on some warps.

P.S. Calm down!!!!!!!!!!!!!!
mofimadness's avatar
mofimadness
4,152 posts
 
Maybe the counterweight is hitting something on the back of the arm? If it's close to the pivot point, it could be bumping the back of the arm or the lift mechanism or the anti-skate assembly or the mounting base?
Ag insider logo xs@2x
uru975
684 posts
 
very very unlikely but it took about 3 records for me to figure it out. My dust cover is off during play, wasn't looking or listening and did not notice that one of the hinges that held the dust cover up had gone forward not stayed back as it should. Caused skipping in the begginning until the arm had moved past it. Height of vinyl did not matter though.
yogiboy's avatar
yogiboy
2,678 posts
 
Raise tonearm,The vta is too low,I had same problem with thicker records.
More to discover