Spacer between cartridge and headshell on Breuer

Hi Pcosta!
You´re an angel, got the message right on spot.
Getting thinner spacer on armboard for Raven One will solve the problem.
Dealer told Thomas to send one.
I wish it was the armboard with VTA on the fly but it cost more than 1000 euro (smart and quick testing different carts).
I´m also waiting for my Mint Protractor.
BTW, instruktions for Breuer was printed on bottom half of a single sheet of paper and no protractor. Not much considering price.
What about antiskating, is there any at all.

Many thanks for taking your time, and the rest of you!

You could also try a copper mat effectively raising the height of the LP same as lowering the height of the cartridge with spacer. The Raven One spindle isn't very long though so you might run out of room with mat + LP + clamp.

The nob on the top of the pivot is the anti-skate adjustment.

I had the same issue when my new Graham Phantom II arrived in June. I fitted it to my TW Raven One but could not get the back of the arm parallel to the platter using my Transfiguration Orpheus cartridge. I spoke to Graham Tricker, the UK importer of the Raven and he advised me that TW had engineered a new stainless armboard base which was 3mm lower in height. He exchanged one for the original armboard base (not the black bronze armboard itself with the stainells collar) and now I can get the arm level to the platter without running out of travel at the arm pillar. No messing around with headshell spacers or copper mats!

Thanks Drjoe!
I might have to change antiskating later.
I thougt the nob on top together with the other on side were for adjusting ruby bearings, and shouldn´t be touched once set at factory.

Ducatirider!
About the copper mat I think it will be too thick, I´m using clamp+mat.

Today my new armboard/spacer should arrive and Mint Protractor should arrive next week.
Looking forward, I will notify the outcome.
Tanks everybody!