Thanks for your insight, Al. At this point I will probably pass on the extra set of cables and just get better jumpers. But if the system matters that much, here you are: Tube amp--AudioPrism Debut Mk1. It is very flexible in that the output can be set to 2,4,6, or 8 ohms, and the feedback has settings for each of those outputs. Right now I'm using the 4 ohm output setting and the '6' feedback setting. Only problem is that the bottom panel must be removed to make any changes. I think it has 16 screws!
My speakers are the Spendor SP 9/1. They have a 5.6 minimum impedance, and are rated at 91dB sensitivity. The MI3 cables are 8 feet long.
So, good or bad match for the bi-wire option?
Thanks again.
My speakers are the Spendor SP 9/1. They have a 5.6 minimum impedance, and are rated at 91dB sensitivity. The MI3 cables are 8 feet long.
So, good or bad match for the bi-wire option?
Thanks again.