Which way to go for a long interconnect.....


I was about to purchase a 15 foot single ended interconnect Alpha Gortz TQ to run between my ARC LS25 and ARC VT 100 mk2. I was informed that they might be too bright for my system (speakers are Infinity RS 1-B's). I wanted to keep the cost as reasonable as possible but was also concerned about the long lenght between components.
What are you suggestions, and please tell me what you think about the Harmonic Pro-silway cables.....they may be a good match for my electronics.
rwd
I've tried the pro-silways and have had mixed results with them in a system cabled with silways, truth links and pro-9 speaker cables. Between the CD and the pre-amp they were glaring and irritating. The bass was tight and accurate but there was also a reduction in warmth of the mids compared to the truth links. The truth links were more musical and seemed pretty neutral relative to live music, however the bass was not as articulate...a bit fuller though. With the truth link in the CD location and pro-silways between the amp and pre I though there was the best of both worlds. The truth links provided the body and the silways gave a little more air on top without being glaring. I ended up needing 20 ft runs and i found some truth links for cheap so my ICs are all truth links now and i can't say i really want to change anything. The truth links are single ended and i have not had any noise problems even considering the fact that one side had a much shorter run and the excess had to be bunched up. The pro-silway whent to between a low-buck phono pre-amp and my pre-amp and it is working fine there as well. For the money the Truth link is hard to beat though i would like to try a long Silway again if i could find one cheap enough. System: VTL 5.5 pre-amp and MB 185 monoblocks, ARC CD-2 player and Dunlavy Athenas.
Can you use balanced cable between those components? You'll notice a differnce on long runs like that...

sorry, I can't comment on your cable choices above...
I have used a 15 ft run of Coincident CRT interconnect between my First Sound Preamp and Art Audio amp with good results. The sound was very immediate and musical without any glare. I have since replaced the Coincident ICs with a reterminated 14' pair of Nordost Quattrofil ICs which proved to be a little more laid back, but at the same time more detailed, open and revealing of a sense of space.

I have no experience with Pro Silway, but from what I heard from other people, I have a hunch it will be very open and airy in your system but perhaps a bit "light" and diffuse (unfocused) at the same time.

My experience with AR electronics (a bit dated, I must admit) leads me to believe that you might prefer the warmer, more engaging sound of good copper cables in your system to the more open, airy but "lighter" (sometimes brighter) sound of silver cables. Quattrofil is silver clad copper, and seems to have given me the best of both worlds. Of course the long run of Quattrofil was quite expensive, and I probably would not have gone to had I not already owned the long pair already and only needed to reterminate it from balanced to single ended. It depends on the type of sound you are chasing.

Hope this helps a little. Good luck.
Ron