OTL or SET? Differences?


With my limited knowledge, I know that OTL is transformerless and SET is single-ended. But what are the main advantages and disadvantages of these two designs? How to choose matching speakers for these two different designs?

Currently I have an Atma-Sphere OTL amplifier.

Thanks in advance!

Otto
yu11375
I own and sell both OTLs and SETs, and would say that they have many of the same qualities. At the risk of overgeneralizing, I'd say that OTLs tend to be a bit more lively and dynamic and SETs tend to be a bit sweeter and warmer (I can comment some on why if you'd like). I've heard superb presentations from systems with both types of amplifiers.

Since it sounds like you have a single Atma-Sphere amp, I presume it's an S-30. As long as you don't ask it to drive a speaker whose minimim impedance dips below 7 ohms you should be fine. An SET would be much more forgiving of lower speaker impedance, as would the larger Atma-Sphere amps. On the other hand if you pair the S-30 with a 12 or 16 ohm speaker, it sounds even better and will put out more power (roughly 45 watts into a 16 ohm load).

The S-30 is definitely a specialty amplifier when it comes to loudspeaker matching. Are you looking for speakers, and if so what are your requirements and ballpark budget?

Duke
Duke, you are right. What I have is Atma-sphere M-30 and it is part of my second system which is for chamber music listening. The project is for my main system as I am experiencing slightly hearing loss on my left ear. That is the reason for me to change my Thiel 3.6 to speakers with high efficiency. I DO love the bass Thiel 3.6 brought me for the past 5 years. Yet I put lots of effort to tame its metal tweeter with little success. I also owned Silverline Sonata I around 4 years ago but the bass from Sonanta I just not enough for me while I listen to Mahler's 2nd symphony or some organ music. Please provide your suggestion.

Thanks!

Otto
Try sopme other speakers.Thiels are way to brite and I like a brite sound.Not sure if you are commited to them that one model is more and offender than another but have thought read the best speaker they made was the CS6.I say difernt because I knwo that my freind had CS 7's (huge with cement bafles-what a bitch egtinbg those to a secopnd floor!!)If going SET I see there are some used Von Schweikert DB99 derived fromsome aburdly priced $60K speaker used for $10K (ouch!).But they got very good reviews have bass covered by 300 wat bass amp but deliver 99DB from only one watt!!!But the price and size maybe more suited for main system not a smaller chamber one.
Me I've thought of inexpensive Omega's for bedroom system with maybe a Fi using low power 2A3 while my main rig will be high powered SS or higher powered tubes (wish I never sold that Mesa Baron.While not SET you could swith it's 12 tubes in banks of four from pentode to triode "on the fly" suiting the amp to different music geting 60/90/120 in full pentode you selected.
I bought a pair of German Odeon Tosca's which is a semi horn and dealer sold Atmasphere and said he had many happy customers match them up (horns like wonderfull Avantegardes and others tend to be very efficinet and might be worth hearing but again size/expense of many may not suit and subs can be difficult.Only REL and other subs which are VERY fast usually using multiple small drivers can even try to blend with horns,electrostsic or planar speakers like Maggie.Everything sub wise is mainly to sluggish.
Not fammilar with sound of OTL but from above even though I like dynamics and speed sounds like I'd prefer the SET sound.Nothing beats lot's of EL34 power for a great midrange in medium efficncy and B300,2A3,845 etc in high effciency speakers.
Chazzbo
Yu11375,

The Atma-Sphere MA-1 and MA-2 amps are far more flexible in handling a wide variety of speaker loads than the lower output Atma-Sphere amps (S-30 and M-60). With the increased number of output tubes, they have much lower output impedance (as well as higher power) making them much more flexible partners. The MA-2 will drive just about any speaker whose minimum impedance doesn't drop materially below 3.5 ohms. With the MA-1, you need to be a bit more careful in speaker matching, but still a broad selection. With either the MA-2 or MA-1 and appropriately matched full-range speakers, you will get bass impact, resolution and agility that is as good or better than you can get from the best solid state amps I've listened to. Plus, you get that magical reproduction of timbre and harmonic overtone structure that only tubes provide.

In contrast, SETs, as mentioned above, deliver a magical quality through the midrange that can be quite addictive. SETs are often described as sweeter and more "musical;" never quite "accurate," but making the music more beautiful than real -- all of which can be a good thing given all the trade-offs we work with. But, a big trade-off for a classical music listener is that I've yet to hear any SET/speaker combination that can begin to deliver on complex orchestral music (like the Mahler 2nd) or large organ. (There may be a combination of SET and horns out there that does this, I just haven't yet heard it.) If your primary listening preference is small ensemble jazz or chamber music or singer songwriter, SET can be a wonderful way to travel. But be prepared to trade-off on more complex music and on music with substantial mid- and low-bass information.

On the flip side, the Atma-Sphere OTLs will be very neutral, very detailed, highly resolving -- in the words of a listening partner here: pristing like a clear glass onto the music. They won't make the music more beautiful, you'll simply get what's coming from your front-end source without editorial.

N.B., I'm an Atma-Sphere MA-2 and Avalon Eidolon owner.
.
I owned both the Lamm ML2 (SET) and the Tenor 75wi (OTL) for a while. I compared the amps with many speakers I had ranging from Kharma to Von Schweikert to Horns to Druids. I found the Tenors to be more sensitive to impedance and the Lamms more sensitive to sensitivity. This is by no means a scientific explination, but based on the limited combinations I've listed above. The Lamms could drive just about any speaker full range at reasonable volume levels. Based on the efficiency of the speaker, the Lamm would start to harden at higher volume levels. The Tenor however could play very loud even with inefficient speakers. However, they would loose control of the bass even at moderate volumes with speakers that had impedance dips. In general the distortion with Lamms was a hardening of the overall sound. The distoriton with Tenors was a boomy bass response. I'm not sure if this is OTL vs. SET or just the difference between Lamm and Tenor amps...hope it helps.