rleff
Responses from rleff
| "blown speakers" You could take a driver out 1 at a time and using a DVM measure the resistance of the speaker at the speakers terminals;maybe one is open and if they are wired in series then all the drivers would appear to be non operational. | |
| "blown speakers" What speakers do you have? | |
| Amp Cap Are they soldered to the board or standing upright with screws?The 10K uf means 10000 uf and should have a voltage spec/rating also printed on them.Can you take a pic of these caps? | |
| Speaker recommendations for JRDG Model 6 + BPS-6 I have a pair of these(no bps) and run them on usher rw 729's and soundlab m2's;the results are stellar and when on the soundlab's they sound very close to my audiovalve challanger 180 monoblocks.I think there probally is not a speaker that they c... | |
| Speaker Choices What are you going to be driving the speakers with? | |
| "blown speakers" I would have to agree it maybe a crossover failure as well;any chance it is fuse protected,do you have the crossover out or viewable? | |
| Do speaker makers customize drivers? If the driver is special to you speakers I would talk with Bill Legall of Millersound.Millersound 1422 Taylor RoadLansdale, PA 19446-1531(215) 412-7700 | |
| "blown speakers" If you can move the driver over to the other speaker; pay attention to which wire goes to the proper terminal of the driver to see if the problem moves;if it moves then you have identified the driver as being bad.If these are a expensive or specia... | |
| D class amps with Soundlab speakers I want to thank everyone who has responded thus far. | |
| D class amps with Soundlab speakers Ralph it would seem to me that the D class amps would have a hard time with the soundlab speaker because they are so compact without weight; this to me says the power supply section would be lacking and not be able to make the power as the speaker... | |
| Specs on PSE Studio Mark IV Hgeifman last I knew it was not but when I talked with Dean in 2010 we was still supporting his products so thats why I put up his contact data if people needed it. | |
| D class amps with Soundlab speakers Dob thanks for the feedback;I was starting to think it was a combination that may not be very good;I presently have m2's with upgrades and audiovalve challanger 180 monoblocks so I completely understand the magic that you are describing;thanks again. | |
| Van den Hul VDH1000 Monobloc Amplifiers - HELP Do you know what the speaker loading on the amps are?Are the speakers connected directly or through a switch? | |
| Specs on PSE Studio Mark IV Phd I have a pse hl-1 pre amp from pse and have Dean's info in case you need repair as he was still involved in support of his gear last I talked with him;he is a real nice person to talk with.Dean Klinefelter;Phone number is 763-295-1710 for anyo... | |
| I am set on all but speakers, need advice on those If you have the room I would look at the dunlavy scIII and IV's that are for sale. |