viridian
Responses from viridian
| Audiogon etiquette question The way to proceed is to put a firm, and binding, offer in through the Audiogon offer system. The seller will then have 48 hours to accept your offer, decline it, counter it, or let it expire. Either way, you will have your answer. | |
| Speaker Switch That Protects Tube Amplifier Beautiful, Al thank you for taking the time to educate me on that point. I appreciate it. Have a good holiday weekend. | |
| Speaker Switch That Protects Tube Amplifier Al if one uses a break them make switch would the amp not see a load for a moment as it is switched😢? | |
| Which MM Cartridge for under a grand Nagaoka MP-500 for a full and chunky sound, Ortofon 2m Black for a brighter sound. Also have a look at Soundsmith and Clearaudio. | |
| Speaker Switch That Protects Tube Amplifier If I were doing it, I would use a make and then break switch that would put the two loads in parallel and use a load resistor of much higher impedance then you are using so that in parallel with the speaker load it would still be within the accept... | |
| HK Citation II amp Contact Jim McShane, he wrote the book on the Citation ll. | |
| Is Vinyl Worth It I feel the same about having chosen a real wife over a blow up doll. | |
| Gain stages on Preamp Volume controls are very imperfect beasts. They are at their most linear completely open, out of the circuit. The further you turn them down the less linear they become. So the purpose of adjustable gain is to be able to use the volume control ove... | |
| Weird problem. Bad tube or something else? I would put one EH tube in one channel and a 7308 in the other. If you have problems first switch sides and then sub the other 7308 for the one in the amp, then again switch the tubes side for side. This will tell you if the issue lies with one ch... | |
| Weird problem. Bad tube or something else? Geoff must you persist in forwarding that tired old canard? | |
| Weird problem. Bad tube or something else? The guy you bought your Mallards from was probably a quack. | |
| Weird problem. Bad tube or something else? I usually retension the sockets as well using a dental tool to gently pull out the metal receivers that make contact with the tube pins. Sounds like you have solved the problem.It's all system dependent but IMHO the Amperex tubes should be a large... | |
| Does sellers responsibility end at FedEx? There is really no reason to ask this question here as it is not a matter of opinion, it is clearly covered in the Audiogon Member FAQ to whit:"The Seller in all cases is responsible for delivering an item as described in his ad."IMHO, even though... | |
| Dynaco PAS-4 preamp Here is a link to the owner's manual, provided by that fabulous Dyna expert Bob Latino:http://www.tubes4hifi.com/Dynaco%20PAS-4%20manual.pdfI hope that helps. | |
| Dynaco PAS-4 preamp Yes, it's from the Panor Dyna years, when Panor got control of the name. They were formerly Stereo Cost Cutters. Good build quality and nice sound as you point out.Panor made a few tube amps as well. The Dyna ST70 MKii was a bit of a turkey, IMHO.... |