-Which pickup are you using?
Turning the volume up
Hi. I'm new to analog and just purchased a Mobile Fidelity Ultradeck table. After completing my set up and putting on my first album i find i really need to turn the volume knob up much higher than when I'm listening to my digital source. Do I have a compatibility problem with my phono stage and cartridge?
I'm using a Belles Aria integrated amp.
Thanks
I'm using a Belles Aria integrated amp.
Thanks
15 responses Add your response
I use this outboard attenuator on my CDP to lower the volume to match my phono. You are better off using the volume in the upper range of the dial on your preamp. BTW, between 12 and 1 is perfect! http://www.schiit.com/products/sys |
The standard for consumer gear had been 0.5 volt output.So all phono, tape, FM radio gear was generally at the 0.5 volt output. And we all lived happy. Then came CD. And for some unknown reason, CD manufacturers decided to NOT use the consumer standard, but used the 2.0volt professional standard. So ever since all digital sources have been much louder than the other sources. Few preamps adjust for this, and actually most preamp/amp combos have too much gain for some digital sources.. |
I have an Audio Note IQ3 cart (6.5 mV) mounted on my Nottingham Interspace Jr. TT's tonearm and I have to increase the gain as well. Very common for an analog front-end because vinyl requires more gain (power increase of the signal) than your digital sources. As @tkr pointed out, the output of your cartridge although low is within normal range. Explore other MM cartridges with higher output but don't be surprised if you still find yourself turning up that volume control knob. Enjoy! |
Maggie, Nope. Elizabeth is referring to what "full range output" means. That is, the maximum output from a CD player via fixed RCA outputs was decided to be 2V. More here: http://www.lavryengineering.com/wiki/index.php/Line_level Best, E |