Biwire Cables for Vandersteen 2CE Signatures

@peter_s   RV is Richard  Vandersteen and Low is Bill Low the proprietor and cable wizard of Audioquest.  You've been getting a lot of good advice here.  Vandys and AQ cables play very well together.  

@peter_s   I forgot to mention your wisdom of using a Rev. A .5 McCormack amp with the 2Ce Signatures.  I use Rev A+ DNA 1 with my Treo CTs.  McCormack and Vandersteen's are another one of those synergistic combos!

I have heard that a true bi-wire run, (two pairs) of  Audioquest GO-4 speaker cable are absolute killer for Vandersteens.

Side question. I see the terms true and external bi-wire and not sure what they really mean. If the amplifier has only one pair of output port per channel the wires pair(s), inside the sheath or outside, need to be twisted and single terminated on that end. Is there any other way?

an internal biwire normally has 4 wires per channel in a common sheath - very little physical space between HF and LF conductors
principal theory being the large current demands of LF and the field that generates modulates the HF signal = degredation

a shotgun typically has common termination at amp ends but splits the HF and LF runs into different cables that importantly can then be spaced 3-4” apart

you can kind of get same effect w two sets of cables, i personally dislike stacking spades and trying to get a gas tight connection and not get shorts at the amp end, hence my preference for shotgun

hope that helps