Amps for Paradigm Persona 3f
Return, We might be able to assist you directly we sell many of the major brands of electronics. We sell the Anthem STR, the Antem STR Separates, T+A integrateds, Micromega, Naim, Electrcompaniet. NAD Masters, and we usually have a few trade in amplifiers around. It will come down to sound and features. Not all of these make magic with the Personas. Doesn’t your dealer also sell the Anthem STR products? The Anthem, STR amp and preamp on good cables and power conditioning produced some of the best sound we have heard with the 3F. The seperates are easily worth the extra money over the STR integrared. Personally I would take a T+A integrated over any thing other then the seperates but the R series costs $11,500 while the HV series costs $18k! The STR integrated seems to be voiced differently, we dramatically prefered the Micromega M100 over the STR integrated with the 3F. Cables do make a huge difference, Contuzzi isn’t right on that one. Dave and Troy Audio Doctor NJ |
Our setup is with Wireworld Platinium or Gold int. We are using Wireworld Silver speaker cables. Power conditioner Isotek or Audio Magic. If you are ever in the NYC area please come over and hear our setup. We are remerchandising this sound room so we will have some demo cables if you need them at good prices Dave and Troy Audio Doctor NJ |
returntomusic OP38 posts Bit hard to tell without a complete overview of a impedance v phase graph, as they’ve only selected 3 different points to give in print, and those "could" be doctored/selected to look easy. But with what there is to work with. 1: In the bass: Impedance reaches a minimum of 4.42 ohms at 141 Hz and a phase angle of –60.68 degrees at 98 Hz. This could be seen as a potential problem for amps by the amp, as a EPDR load of around 2.5ohm to 3ohms in the bass 2: In the Highs: With 3.49 ohms at 16.1 kHz with phase angle of –53.22 degrees at 18khz this is a potential problem for amps, as it could equate to around an EPDR load as seen by the amp of around 2 to 2.5ohms in the highs There’s nothing measured for midrange frequencies. With what we’ve got here, because the 3f’s are 89db efficient, a 100w or higher amp into 8ohm will do. But it looks to me from the above measurements it’s a speaker that need a bit current also from the amp, that is solid state amps that can "almost" double their wattage from 8ohms to 4ohms to 2ohms would be great. EG: 100w 200w 400w. Even though they may work, I’d stay away from tubes with these, if you want the very best out of them. Cheers George |
