JC3+ With Kleos SL?

Keep in mind that the rated output of a phono cartridge is only a representation of what it does at one particular stylus velocity (3.54 or 5.0 cm/sec). When you are playing actual music the stylus is moving faster than the standard velocity most of the time. Therefore the actual output of that cartridge while playing music is going to be greater than its rated output most of the time. And the difference between 64db and 65db is of course trivial. In other words, no problemo.

Good points lewm.

Lyra is using 5 cm/sec as stated here:
http://lyraanalog.com/kleos-sl.html

And again they mention rigid bearings.

Thanks,
Robert

Have both the Lyra Helikon and the Lyra Helikon SL, the SL is quite a bit better than the higher output standard model and yes 64 db of gain with your J3 should be fine, go for it.

@robbob, since you had already made up your mind, I'm not understanding the point of your OP??


If the phono stage is working too hard to amplify the signal, you will get distortion...unless you are going to be happy with a very low output from your system. I know this as I went through exactly the same problem with a very low output MC and my phono stage. Output was 0.25mv and the phono stage was good for 64db of gain. 

I had not made up my mind at the time of the original post.

Interesting you got distortion.  The gain of the phono stage is fixed so I would expect noise but not distortion.  A low input will give a lower output.  One's preamp may distort trying to make up the difference.  That is unlikely with the CP-500, particularly at the reasonable levels at which I listen.  Will give that issue some more thought.

Thanks for the replies,
Robert