imhififan
Responses from imhififan
| Help with settng Lyngdorf 2170 Dose your Lyndorf 2170 comes with analog line level output? | |
| RMS Power? https://en.wikipedia.org/wiki/Root_mean_square | |
| Need help with system connection I think any sort of switcher will degrade signal purity and sound quality since it has to go through another circuitry. @caphill, There’s a switching circuitry in the analog preamp for HT bypass!DAC1 > analog preamp input selector > volume c... | |
| Need help with system connection Obvious question: will there be a sound degradation of any sort? Not to my ears, I use a xlr switcher on ML-26S preamp to DAC and phono pre years ago. | |
| Need help with system connection IME, Goldpoint is very good. http://www.goldpt.com/sw2x.html | |
| Need help with system connection A line level A/B switcher connect to Simaudio W5 input and you can select Benchmark DAC1 or Marantz AV7701 as a preamp. http://www.goldpt.com/sw2x.html | |
| Please help! Tube amp issue @jetter, OP solved the problem by swapping the wires of output transformer on primary side as suggested. https://www.diyaudio.com/forums/tubes-valves/330414-please-help-tube-amp-issue.html | |
| AV7704 Audyssey https://audyssey.zendesk.com/hc/en-us/articles/212341603--Phase-error | |
| Attention Manufacturers: What I want is a TINY HT processor! https://usa.denon.com/us/heos/heos-avr | |
| Thiel cs2.4 upgrade to cs 2.4 se Hi guys, i intend to get claritycap csa 10 ohm + 3.9ohm to replace the original caps 13ohm +1ohm and claritycap csa 10ohm +18ohm to replace 27ohm + 1ohm original caps. Do i need to change or remove any resistors? I think you mean 10uF+3.9uF an... | |
| Recommend powered center / surround combo that won't break the bank? Denon HEOS system? https://usa.denon.com/us/heos/heos-avr | |
| Tube tester: Orange VT 1000 @tsbel, great info, thanks! | |
| TAD 150 Signature preamp remote sensor out? I asked him to see if there's a way to bypass the controller, switch modes manually, and wire up a separate remote to the volume pot-motor. He's going to look into it...Ask him if he can make use of this kit: https://www.ebay.com/itm/Assembled... | |
| Powering nine home speakers Best to have each speaker with its dedicated amplification so you can adjust each channel level for evenly distribution. | |
| Powering nine home speakers I thought you have a HT setup using the onkyo in a dedicated theater room and want to switch the music to your living room? |