Tekton Double Impacts

@nitrobob Merry Christmas to you. Are you primarily listening to 5.1 or above recordings?

@brotw   Given your work and knowledge of the area, do you have any recommendations?

I've considered Star Sound Technologies as well as the IsoAcoustic Gaia. I'm currently using Herbie's products, to good effect. Thoughts?

brotw, nice post on controlling cabinet resonance--takes some of the mystery out of how these devices work. 

As many of these devices are rather expensive, does anyone have any thoughts on the more cost effective products out there or any DIY products?

As stated, the DI's have rather lively cabinets.  I have my pair on steel outriggers with hard rubber footers on vinyl planks over concrete.  While this is a very stable arrangement, I suspect it does little to drain xs energy from the cabinet.  What about multiple sorbothane pucks under the cabinet with optimal compression as a way to drain cabinet energy  while still keeping the stability of the outriggers?  Or, what about sorbothane sheets or even vinyl floor tiles inside the cabinet?

@corelli

Seems like with the devices your using might just be changing the resonant signature of your cabinet with the rubber devices. The best vibration draining systems I have have used are ball bearing isolation devices under my components i.e. Symposium Roller Blocks, Aurios, isoacoustics Gaia’s etc.

If your interested in DIY route. You might want to search for "DIY Roller Blocks" or "Barry Diament hip joints"

I agree corelli, Brotw helped take some of the mystery on how isolation devices work for me also and I'm experimenting with a few different isolation options. 

For my DI's I've tried the Mapleshade Heavyfeet brass carpet spikes and Herbies Giant Threaded gliders before going with the Gaia I's. The first two were much better sounding than the stock spikes but neither come close to the improvements the Gaia's bring to the table IMO. 

For my electronic components I've been using the Mapleshade brass Heavyfeet under the components sitting upon their 4" thick maple platform upon their isoblocks. I just ordered a set of four Isoacoustic Isopucks and Symposium Rollerblock Jr's to try in place of either the brass Heavyfeet or the isoblocks. I'll try replacing the Isoblocks first as the theory is that the brass Heavyfeet transmit vibration from the component into the maple platform for it to disappate and the isoblocks isolate the platforms from vibrations from below. At least that's my understanding. So I'll try replacing the isoblock with the other isolation devices first to see if I hear a difference so as not to disrupt Mapleshades process. Then I'll try replacing the brass Heavyfeet with the new isolators. Might isolators above and below the maple platforms work even better? Time will tell. 

Thanks to aniwolfe for mentioning the Symposium Rollerblock Jr's, they're quite interesting. FWIW I went with the HDSE option.